Do you know the reason why the mine screen is deformed?

The deformation of the mine screen occurs during cutting, which is the result of the fine bending deformation of the complex mine screen on the shear product. Therefore, the easier it is for the material to produce plastic bending and small rebound, the greater the residual deformation and distortion. How to deal with the deformation problem of the mine screen When the width of the shear band is narrow, because there is no bending, the part that prevents deformation becomes smaller, thereby increasing the deformation.   Although the mine screen is bent in the direction of the shear line, it is also bent in the width direction. The screen plate is reduced to form a cantilever beam. Because it is not on the shear line, it seems that because of the forced indentation of the upper front edge, the shear line in the direction of the elongated deformation is produced. Because of this continuous accumulation, the bending deformation in the width direction increases, which leads to the complex deformation caused by the deformation combination.   Although the shearing and cutting mechanism of the mine screen and the screen does not change much due to the influence of the shear angle, the material in contact with the oblique blade will be deformed, but it should be noted. Assuming that the cutting material is fixed on the lower edge of the cutting edge, the slit of the slit will be deformed, and the general effect path is constructed on the data function, which can adapt to the ability of various mesh surfaces. In practical work, the cost of maintaining the selected raw materials should be considered.   Most of the load-bearing materials on this mesh are consolidated and straightened on the mesh surface, and the mesh size is uniform, etc. It shows the implementation of various raw materials. The adaptability of the mesh structure to the long and long functional self-adaptation principle is a reference to the selection of ore and coal particles. In terms of application, enhancing the function of the company also requires continuous appropriate welding, packaging, bending and other technologies along the entire edge.